The seawater pump finally changed from an electric pump to a belt drive. The biggest problem was where to place it, in the end suitable and the only such place was found under the charger. To do that, I had to make a mounting piece that I bolted to the front mounting bracket of the […]
Read more
Launch
Launch was – again – just before midsummer. The original planned date was much earlier…. New prop going.
Read more
Bilge getting closed
The new bilge top plates are getting welded to place and one critical work starts to be ready, at least almost since some paint is of course needed on top of Zinga.
Read more
Varnishing
All four cans of varnish went to the right place=Ariadne. Even more would have been good, but 2-3 layers was quite acceptable.
Read more